Pump: 2642 gallons per hour, 115v, 1/3 HP, 147 watts (max), 1.3 amps, Asynchronous, energy efficent, much higher volume, no motor seals to wear in dirty/abrasive water.
Nozzles Five Nozzle patterns (4 shown above) plus geyser (not pictured).
Heights: 4-6 feet. Widths up to 12 feet.
Float: High Density 18" black resilient closed cell plastic foam float (water resistant, will not absorb water), UV resistant, CFC, HCFC free. Will accommodate optional light fixtures.
Power Cord: 50' Standard 3 prong plug end
Timer: 115v outdoor timer with two outlets
Filter: Intake screen/ debris filter included
GFCI: Ground Fault Circuit Interrupter Electrical Protection Included.
Warranty: 1 Year Limited Warranty on Pump Note: The original pump, wire and attached waterproof splice must be returned, in its entirety for pump warranty consideration, any deviation from this requirement will void all warranties.
Anchoring Line: 50' of anchoring line included.
Lighting Options: Easy to install 3 fixture MR-11 light set with both Halogen and LED bulbs.
Approximate Operating Cost: $ .03-.07 per hour
Minimum Water Depth: At least 3-4 feet of water recommended
WARNING: These pumps are not designed for use in salt or brackish water.
Water with high concentrations of salt, sand or minerals is very corrosive to seals and bearings.
Please be aware that these conditions will affect the longevity of your pump and may cause damage that is not covered under the manufacturer's warranty.
*** Flat Rate Shipping depending on the model to the U.S. 48 States ****